METHOD OF INSTRUCTIONS:
Step 1 Cleaning and preparation
Apply a small amount of Tri-Phase cleanser to dry face. Massage into the skin for 1 minute to thoroughly cleanse it and remove any traces of make-up with a disposable wet wipe. Repeat again. If necessary, deeper cleansing should be performed for problem skin.
After using Tri-Phase cleanser, apply an almond sized amount of Micro Derm Exfoliant to slightly moistened hands and exfoliate in gentle circular motions. Completely remove all residue with gauze.
Step 2 Treatment with Dermapen MicroNeedling
As per instructions.
May apply ÜBER MD by line peeling to target area of concern immediately post 1 layer of ÜBER PRO!
Step 3 Apply Chemical Peel
Apply the ÜBER PRO peel to the face using a fan-shaped brush, Stick applicator or gauze (make sure it does not drip) starting from the forehead, followed by the cheeks and nose (working down and around the face). It is important that the application be as uniform as possible (be careful not to forget areas or overlapping strokes). Avoid the area of the eyes, ears and lips.
May apply up to 1-2 passes of ÜBER PRO Peel. Pay close attention to the level of redness, frosting, and to each patient’s pain threshold before applying the next pass. Be sure to wait 2 to 3 minutes between each pass. If necessary, fan the patient’s skin to provide comfort.
END POINT FOR ÜBER PRO: Mild erythema, slight tingling, warmth.
Step 4 Neutralize
Once end-point is reach, apply HylaActive or SparK+Vit-K to neutralize the peel.
Step 5 Brighten
Apply Brite Lite melanin suppressor to inhibit melanin production.
Step 6 Heal and Hydrate
Massage lightly with Vitamin Rich Repair on the treated skin.
Step 7 Finishing Sun Protection
For deep sun protection evenly apply SPF30 or colour specific Cover Recover over face, neck and décolleté.
ÜBER PRO Full Ingredients:
L-Mandelic Acid, Alcohol Denat., Water (Aqua), Resorcinol, Dimethyl Isosorbide, Pyruvic Acid, Lactic Acid, Niacinamide, Kojic Acid, Arbutin, Retinal, Sodium Hyaluronate, Copper tripeptide-1/Bis(tripeptide-1) Copper Acetate, Glycerin, Caprylyl glycol, Ethylhexylglycerin, Ferulic Acid, Hydroxypropyl Cellulose.